Trouble Shooting Tools
3-in-1 kits that replace a fridge or freezer compressor's start relay and overload with a solid-state relay, an overload and a start capacitor, so a single-speed compressor starts reliably on weak or sagging power. Three sizes, by compressor horsepower.
Explanation
- Fridge and freezer makers leave the start capacitor out because on grid power the compressor starts easily: refrigerant pressure evens out while it is off, and a wall outlet delivers the startup surge without strain. Inverters, generators and sagging batteries are different. The voltage dips when the compressor starts, and an inverter can deliver its surge rating for only a moment, so a compressor that starts fine on the grid can stall.
- The worst case is a restart right after a power blip or an inverter trip. Most fridges start through a small ceramic part (a PTC starter) that has to cool for a few minutes first, and the refrigerant pressure has not evened out yet, so the compressor stalls at full startup current and clicks on its overload until both settle. The start capacitor gives the motor extra torque for the first moment of each start, so it can push through low voltage and uneven pressure instead.
- Less time stalled at startup current means less heat in the motor windings, which helps the compressor last, above all where power blips and inverter trips are common.
- It does not cut the peak startup current much, so it will not let you buy a smaller inverter. What it does is make starts reliable on the inverter you have, including from a power-saving search mode such as Victron's ECO mode, where the inverter has to wake up as the compressor tries to start. Test that over a few cooling cycles: the compressor should start first time, with no clicking from the overload.
- The kit sits after the thermostat, so between cooling cycles it has no power and draws nothing. It never keeps an inverter awake.
- Pick the size from the horsepower on the compressor's own label: RCO810 for 1/12 to 1/5 HP (small fridges and chest freezers), RCO410 for 1/4 to 1/3 HP, RCO210 for 1/3 to 1/2 HP. The kit replaces the overload too, and its overload is made for the whole range, so on a compressor at the very bottom of a kit's range it may let the motor stall longer before cutting out. A compressor in the middle of the range is the best fit.
- The small kit here is genuine Supco, because a small compressor leaves the least margin for error. The two larger kits are lower-cost copies of Supco's RCO410 and RCO210, where there is more margin.
- Never fit one to an inverter (variable-speed) compressor, such as the one in the ZAFRO window air conditioner on the Heating and cooling list. Those motors are run by an electronic drive board and have no start winding, and a start capacitor on the drive's outputs would destroy the board. Check the compressor first: a single-speed one has three pins under a plug-on relay; a variable-speed one is wired to a separate electronic control box. Avanti does not say which kind the chest freezer on the Storage / Appliances list has.
- Unplug the fridge or freezer before fitting a kit. The kits fit 115 V compressors on capillary-tube systems, which covers almost every household fridge and freezer.
Tech specs
RCO810 (Supco) 1/12 to 1/5 HP, 110 to 125 V; one kit RCO410 (Swess) 1/4 to 1/3 HP, 115 V, 243 to 292 µF; three kits RCO210 (BlueStars) 1/3 to 1/2 HP, 115 V; one kit Each kit solid-state start relay, overload and start capacitor, pre-wired Fits single-speed fridge and freezer compressors with a plug-on relay and overload; not inverter compressors Figures from the Amazon listings.
- View on Amazon
An inspection camera on a 5.5 ft waterproof probe whose 8.5 mm tip steers up to 220° in two directions, with lights and a 4.3-inch screen on the handle, for looking inside walls, engines, pipes and machinery. No app or phone needed.
Explanation
Endoscopes are useful for a huge variety of tasks, but their usefulness depends on how well the screen, camera and light work. As of 2025 this one was among the best for the price. Better models may have come out in 2026, but likely cost more.
Tech specs
Probe 5.5 ft semi-rigid gooseneck, 8.5 mm tip Articulation two-way, 220° Camera 1080p, 2 MP, 8x digital zoom Focus range 1 to 15 cm Light 8 LEDs, 4 brightness levels Screen 4.3 in IPS Waterproofing IP67 probe, oil resistant Battery 3000 mAh, about 4 hours; USB-C charging Storage microSD, 32 GB card included Included hook, magnet and side-mirror tips, hard case Model AGC430N Warranty 12 months Figures from the Amazon listing.
- View on Amazon
A handheld thermal imaging camera that shows surface temperatures from -4 to 1022 °F, for finding overheating wires, connections and parts. A second, ordinary camera can blend its picture with the thermal one, and images go to a phone over Wi-Fi.
Tech specs
Thermal sensor 256 × 192 VOx (shown upscaled to 640 × 480) Thermal sensitivity under 40 mK Temperature range -4 to 1022 °F Accuracy ±3.6 °F or ±2%, whichever is greater Frame rate 25 Hz Screen 3.2 in Visual camera 2 MP; thermal, visual, fusion and picture-in-picture modes Connectivity Wi-Fi to phone or tablet Other LED flashlight, 1/4"-20 tripod mount, adjustable emissivity, high and low temperature alarms Battery rechargeable lithium-ion, included Figures from the Amazon listing.
- View on Amazon
A 60x to 250x microscope camera on a flexible arm stand, for inspecting circuit boards, solder joints and small parts. It has no screen: it shows its picture on a computer or tablet through ordinary webcam software.
Tech specs
Magnification 60x to 250x Camera 2 MP Light LED ring, adjustable brightness Connection USB, with USB-C adapter; standard webcam driver Works with Windows, macOS, ChromeOS, Linux, Android, iPad Power 5 V from the USB port Size 3.5 × 1.25 × 1.25 in, 2.9 oz Warranty 2 years Figures from the Amazon listing.
Optional Upgrade
- View on Amazon
A digital microscope with its own 10.1-inch screen, three lenses (up to 2040x), a metal stand and soldering helping hands. It can also send its picture to a larger screen over HDMI.
Explanation
A cheap screenless microscope is fine as long as your computer still works. It is not fine if the computer is what stopped working; this one needs no computer.
Tech specs
Screen 10.1 in, built in Lenses (on its own screen) L 15–60x for soldering, A 4.5–180x general, D 450–510x for slides Lenses (on a 28 in HDMI monitor) L 60–240x, A 18–720x, D 1800–2040x Video 2160p, to the included 32 GB SD card Outputs HDMI; USB to a Windows PC Light LED, 8 brightness levels, plus a bottom light stage Stand metal, 18.1 × 14.6 × 18.7 in, with tool holder and soldering helping hands Power mains adapter, included Warranty 2 years Figures from the Amazon listing.